Copyright Swiftech 2005 – All rights reserved – Last revision date: 8-16-05
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769
E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com
Page 1
Packing list
Parts Qty Parts specific to AMD installations Qty Parts specific to AMD installations Qty
Heat Sink 1 AMD Brackets 2 Black fiber washers 6
40mm fan & screws 1 4-40 x 3/16” socket screws 2 Nylon spacers 2
Wire-Springs 2 4-40 x 1 ¼” Philips screws and
mini-nuts
2 Knurled knobs 2
Thermal grease – Arctic Céramique 1 Nylon tensions limiters 2 Springs 2
Neoprene pads (strip of 4) 1 Hex wrench 1 4-40 x 3/8” socket screws 2
Pre-installation Notes
a. The MCX159-CU ships with 4 small neoprene pads. These are used for two purposes: stabilize the heatsink, and minimize the risk of
damaging the processor core upon installation. These pads must be removed when installed on chipsets protected by a heat spreader. Below
are examples or when to use the pads, and when NOT to use the pads:
Figure 1 - Pads needed
Figure 2 - Pads not needed
b. The bracket installation and fan mounting holes are spaced differently. Be careful to use the right holes for the correct purpose as
shown below:
Figure 3
Information subject to change without notice
Comentários a estes Manuais