Swiftech MCX478 Manual do Utilizador descarregar pdf

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90806 – Tel. 562-595-8009 – Fax 562-595-8769

E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com

Information subject to change without notice

Page 1

Packing list

Parts Qty Parts Qty

Heat Sink 1 Springs 4

Fan 1 Nylon flat washers 8

Fan guard 1 Nylon 6-32 Hex nuts 4

6-32 x 2” screws (for fan) 4 Black fiber washers 4

6-32 x 1 ½” screws (for HS) 4 Thermal grease 1

Standoffs 4 4-40 socket screws 4

Mounting Brackets 2

I. Preparing the motherboard

1. You must uninstall your MB prior to installing the MCX478 heat sink.

2. Install standoffs in MB.

Nylon, hex nut

on back side of

the MB

Standoff

Install standoff in each one of the four

holes surrounding the socket. Keep the

standoff centered over the MB holes, and

secure with nylon hex nuts on backside

of the MB. If you are going to

assemble/disassemble the heat sink

frequently, we recommend finishing the

installation by putting a drop of “Crazy

Glue “ at the junction between standoff &

MB, and between nylon hex nut & MB.

This will lock the standoff onto the MB,

and further prevent it from spinning lose

during frequent assembly and

disassembly operations.

3. Re-install the MB inside the case.

II. Heat sink Installation

1. Install the two mounting brackets onto the heat

sink, using the provided 4-40 x 1/4” socket screws:

4-40 x 1/4“

socket screw

Bracket

2. For the next step, the case should be laying flat on

a table

3. Insert the processor into the socket, and lightly coat the processor core

with high quality thermal compound. Only a paper thin coat is

necessary. It should be applied using preferably a razor blade, or a credit

card, held between thumb and index at a 45 degree angle. It is critical to

ascertain that the entire core is covered with a uniform coat of thermal

compound. Thermal performance will dramatically decrease if any portion

of the core is not covered by thermal compound. We recommend Arctic

Silver or similar high end compound for superior thermal conductivity.

4. Place the bare MCX478 heat sink over the CPU as shown in the picture

below. The step side should be located over the socket’s cam box. Keep

the heat sink mounting holes lined up with the standoffs.

Socket

cam box

Step

side

1 2

Resumo do Conteúdo

Página 1 - 4-40 x 1/4“

Página 2 - Nylon flat

Comentários a estes Manuais

Sem comentários

Swiftech MCX478 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios para Computador Swiftech MCX478. Swiftech MCX478 User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para Computador Swiftech MCX478