Swiftech MCX4000 Manual do Utilizador descarregar pdf

–

Last re

vision date: 2

2003

Rouchon Industries, Inc., dba Swiftech

–

1703 E. 28

Street, Signal Hill, CA 90806

–

Tel. 562

595

8009

–

Fax 562

595

8769

E Mail: Swiftech @swiftnets.com

–

URL:

http://www.swiftnets.com

Info

rmation subject to change without notice

Page1of

For Intel® Pentium® 4 Processors

Packing list

Parts

Qty

Parts

Qty

Heatsink MCX4000 rev 1

Steel Standoffs

Spring assy. (pre

installed)

Hex 6

32 lock

nuts

32 x 2 1/4” screws for 70x15mm fans

Fiber washers

32 x 2 ½” screws for 80x25mm fans

Thermal grease

32 x 1 ½” screws for other 80mm fans

Fan brackets

32x1/4” Philips screws

Snap rivets

I. Preparing the motherboard

You must uninstall your MB

prior to installing the MCX4000 heatsink.

Install standoffs in MB

Hex lock-nut

on back side of

the MB

Standoff

Fiber washer

Remove Intel® stock retention frame.

Install standoff in each one of the four holes

surrounding the socket. Keep the standoff

centered over the MB holes, and secure with

fiber washer and lock

nuts

on backside of the

MB.

Heatsink Installation

Insert the processor into the socket

, and lightly coat the core with

the provided thermal compound.

Only a paper thin

coat is

necessary

. It should be applied using preferably a razor blade, or a

credit c

ard, held between thumb and index at a 45° angle. Thermal

performance will dramatically decrease if any portion of the core is

not covered by thermal compound.

Place the MCX4000™ heatsink over the CPU

as shown in the

picture to the right. Keep the heatsink mounting holes lined up

with the standoffs. Tighten the screws gradually in a crisscross

pattern until you feel that they reach the bottom of the standoff.

A “finger

tight” lock is sufficient.

Fan Installation

Use the following provided hardware depending on the fan:

32 x 2.25” screws for 70x15mm fans

6-32x2.5” for 80x25mm fans

32 x 1.5”

thru the fan lower lip

for all other 80mm fans.

6-32“ X 1.5”

Thru fan lower lip

Use 6-32 x 2.25“ screws

for 70x15mm fans

6-32x2.5“ for

80x25mm fans

6-32 x 1.5“ screws

thru fan lower lip for

all other

80mm fans

Tighten heatsink to MB

in criss-cross pattern

70x15mm fan shown

1 2

Tighten heatsink to MB 1
2

Resumo do Conteúdo

Página 1 - Tighten heatsink to MB

Página 2 -

Comentários a estes Manuais

Sem comentários

Swiftech MCX4000 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios para Computador Swiftech MCX4000. Swiftech MCX4000 User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para Computador Swiftech MCX4000