Swiftech H20 220 APEX ULTIMA Manual do Utilizador Página 1

Copyright Swiftech 2008 – All rights reserved – Last revision date: 10-29-08- Information subject to change without notice – URL: http://www.swift

Figure 8 Figure 9 Figure 7 Fasten the hold-down plate assembly to the Apogee™ GTZ water-block Peel-off the protective paper from all four foam st

4. PUMP INSTALLATIONGeneral Use  The MCP655-B pump is a magnetically driven centrifugal pump featuring a 12 V DC motor. It requires no maintenance

Permanent installation to the chassis, and exploded view Nominal voltage / Connector 12 V DC / Molex 4 pin Maximum pressure 50 PSI (3.5 BAR) Op

Figure 1 Port Usage definition Upper side port: “Inlet” as shown in figure 1 is the return line from the system Lower side port: “Outlet (to pump)” s

ITEM NO. PART NUMBER DESCRIPTION QTY.1 BCKT1 "L" bracket 12 BCKT2 "U" bracket 2390272A146-6-32x3-8-philips34 91772A158-6-32X1.756-

6. INSTALLING THE TUBING Gather the Smartcoils towards the center of the tubing, and then pull on the ends of the tubing. This will allow the coils

• Prior to fill-up the circuit, you will need to re-install your power-supply in order to start-up the pump during the fill procedure. You must be ab

8. TROUBLESHOOTING  Air keeps circulating into the circuit, long after the pump has primed: o There is a significant pocket of air trapped into

Packing List QTY ITEM 1 APOGEE GTZ water-block, including socket 775 and socket 1366 hold-down plates for Intel Core® (Core 2, Duo, Quad, Extreme,

TTAABBLLEE OOFF CCOONNTTEENNTTSS I. PLANNING...

INTRODUCTION Congratulations on your purchase of a Swiftech™ H20-APEX liquid cooling system! This kit has been designed to facilitate the installati

 From a performance standpoint there is very little performance to be gained from strictly controlling the component sequence: the maximum delta T (

1. MCR220 RADIATOR INSTALLATION Preamble: The MCR220™ dual 120mm radiator ships with the fans and the Radbox chassis already pre-assembled to the rad

 Installation  Place the radiator assembly on the back of the computer to roughly estimate where it will fit best.  You need to consider the fol

 Remove the radiator assembly from the back-plate and mark the center of the circle.  Two rubber grommets are provided with your kit so that yo

3. Fasten the block to the motherboard 4. Install the tubing For optimal performance, it is critical to orient the water-block properly relative to